Viconics VCM8000V5045P (ZigBee Pro) Installation Guide for Bedienungsanleitung PDF herunterladen (Seite 3)

ZigBee Module Installation Guide

028-0425-01 www.viconics.com | sales@viconics.com November 2014

Quick setup

This short procedure is intended to let you pair a ZigBee sensor with your Room Controller. It assumes that all the back-end conﬁguration

of the stand alone Room Controller acting as coordinator or the Multi-Purpose Manager (MPM) coordinator for the ZigBee network has

already been done, and it assumes that the user is familiar with the Permit Join function and the Wireless Ecosystem screen functions.

PROCEDURE

1. Set Permit Join on your Room Controller (or networked MPM coordinator if used) to On.

2. Go to the ﬁrst unused Zone screen in the Wireless Ecosystem section of the Room Controller’s interface.

3. Insert the battery or remove the pull tab (for contact sensors) to activate the ZigBee sensor

4. Verify that the sensor has joined the network, and that on the Zone screen the Paired ﬁeld status reads Yes.

5. Set the Set function to parameter to the correct setting.

6. Set Permit Join on your Room Controller (or networked MPM coordinator if used) to Off.

7. Conditional to use of door or window contact sensors

a) Go to the ﬁrst screen in the Conﬁguration section of the interface.

b) For window sensor, set UI 16 to Window

c) For door sensor, set UI 17 to Door Dry

8. Physically install the sensor.

TROUBLESHOOTING

If the short procedure described here is insufﬁcient or an MPM or Room Controller needs to be conﬁgured, please refer to the VT8000

Room Controllers ZigBee Pro Wireless Integration Guide available on buildingsdownloads.schneider-electric.com.

1 2 3

Keine Kommentare

Viconics VCM8000V5045P (ZigBee Pro) Installation Guide for Bedienungsanleitung Seite 3